[Q] off leak current?

I'm sorry if I have miss a post address.

Could anyone, please, send me an official answer
about the leakage current?

I have received some local mails.
Thank you very much for your support.

Best regards,
Akimoto

------- Forwarded Message -------

From: akimoto@lsi.nec.co.jp
To: ibis-users@eda.org
Cc: yasufumi@lsi.nec.co.jp
Subject: [Q] off leak current?
Reply-To: akimoto@lsi.nec.co.jp
Date: Thu, 25 May 2000 09:38:27 +0900

I have a question about the IBIS modeling.

Where should we put the off leak current into?
        1) Both CLAMP curves and PULLUP/DOWN curves?
        2) Only CLAMP curves?
        3) Only PULLUP/DOWN curves?
        4) Nothing? (Same as resistor?)

I'm afraid how the board simulators get this information
from IBIS model.
Please, don't ask me more about the off leak current. ^_^

Best regards,
Akimoto

------- End of Forwarded Message -------

------------------------------------------------------
Akimoto Tetsuya
Design systems dep. System LSI Design Engineering Div.
NEC Electron Devices, NEC Corporation
Email:akimoto@lsi.nec.co.jp Phone:044-435-1513
Received on Thu May 25 16:39:29 2000