[IBIS] S2ibis3 power supply assignments for H-spice simulation

Hello,
       we investigate to use s2ibis3 for IBIS file generation using
H-Spice models.

I was able to run the sample files without problem (ex3). After revising
to command file (*.s2i) according to our device file needs, I found no
solution to get s2ibis3 to configure more than two power supplies (2x
VCC/VDD and 2x GND/VSS) in the H-Spice setup.
Is there a way to specify power supply assignments and settings that
keep the same for all simulations that are used within a *.s2i file ?

Thanks and Best Regards,
Gerd Baumann

-----------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with the appropriate command message(s) in the body:
|
| help
| subscribe ibis <optional e-mail address, if different>
| subscribe ibis-users <optional e-mail address, if different>
| unsubscribe ibis <optional e-mail address, if different>
| unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
| http://www.eda.org/pub/ibis/email_archive/ Recent
| http://www.eda.org/pub/ibis/users_archive/ Recent
| http://www.eda.org/pub/ibis/email/ E-mail since 1993
Received on Wed Dec 15 04:23:50 2004