[IBIS] hspice vs IBIS model correlation at different capacitive loads

From: Ummalaneni, Venu Babu \(Venu\) <venubabu_at_.....>
Date: Tue Dec 13 2005 - 02:38:08 PST
Hi Gurus,

I have an ATA* IBIS model and it is correlating well with hspice model
when I am using a 5pF load followed by a transmission line. If I replace
the 5pF load with 30pF correlation is bad (particularly in 2nd page
waveform of attached PDF). 

Could some one comment on this, where it is going wrong?

Your comments/inputs are highly appreciated.

Attachments: ata4nik_5pf.pdf - hspice and IBIS model waveforms captured
using 5pF load
                    ata4nik_30pf.pdf - hspice and IBIS model waveforms
captured using 30pF load

Thanks & Best Regards,
Venu

 <<ata4n1k_30pf.pdf>>  <<ata4n1k_5pf.pdf>> 


-----------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda.org/pub/ibis/email_archive/  Recent
|  http://www.eda.org/pub/ibis/users_archive/  Recent
|  http://www.eda.org/pub/ibis/email/          E-mail since 1993
Received on Tue Dec 13 02:39:33 2005

This archive was generated by hypermail 2.1.8 : Tue Dec 13 2005 - 02:40:42 PST