[IBIS] Open drain strange behaviour

From: Roberto IZZI <roberto.izzi_at_.....>
Date: Mon Sep 11 2006 - 05:17:18 PDT
Hello everybody

  I 'd like to have some information about a strange behaviour of Open 
drain buffer
  Ibis model. I have noticed a mismatch between Transistor level and 
Ibis model
  voltage output during a transient analysis. In fact in presence of the 
same input voltage
  wave and the same value of load resistance (for example 70 ohm),
  we can observe a delay between TL output and Ibis output. This delay 
is the same
  if we change the value of  load resistance. What is the cause of this 
strange behaviour?

  Thanks and best regards

        Roberto Izzi

 
 


--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Mon Sep 11 05:19:31 2006

This archive was generated by hypermail 2.1.8 : Mon Sep 11 2006 - 05:19:39 PDT