Re: [IBIS] [Ibis] How to model an output buffer with internal pulldown resistor

Tom, Arpad,

  Thanks for the guide.

Best Regards,
Gooi

On 10/19/07, Tom Dagostino <tom@teraspeed.com> wrote:
>
>  Gooi
>
>
>
> The pull down resistor should have its characteristics in the ground
> clamp.  Other than that the buffer is the same as any other buffer with the
> exception there will only be transient waveforms with the termination to
> ground.  The model type will be open source.
>
>
>
> Tom Dagostino
> Teraspeed(R) Labs
> 13610 SW Harness Lane
> Beaverton, OR 97008
> 503-430-1065
> tom@teraspeed.com
> www.teraspeed.com
>
> Teraspeed Consulting Group LLC
> 121 North River Drive
> Narragansett, RI 02882
> 401-284-1827
>
> *From:* owner-ibis@server.eda.org [mailto:owner-ibis@server.eda.org] *On
> Behalf Of *Gooi Han Chiou
> *Sent:* Thursday, October 18, 2007 7:54 PM
> *To:* ibis@server.eda-stds.org
> *Subject:* [IBIS] [Ibis] How to model an output buffer with internal
> pulldown resistor
>
>
>
> Hi all,
>
>   I need to model an output buffer having transistor as pullup element,
> while a internal pulldown resistor as pulldown element, how should I model
> this type of buffer?
>
> --
> Best Regards,
> Gooi Han Chiou
> --
> This message has been scanned for viruses and
> dangerous content by *MailScanner* <http://www.mailscanner.info/>, and is
> believed to be clean.
>
>
> --
> This message has been scanned for viruses and
> dangerous content by *MailScanner* <http://www.mailscanner.info/>, and is
> believed to be clean.
>



-- 
Best Regards,
Gooi Han Chiou

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.


--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993