[IBIS] Open drain load conditions

From: Fabio BRINA <fabio.brina_at_.....>
Date: Wed Dec 05 2007 - 09:06:54 PST
Hi ibis experts,

I need some explanation about "Open drain" model type:

In this case, which are the load conditions recommended for V-T waveform?

Have I to introduce R_fixture between Pin and Power to extract V-T?
have I to remove it when I consider Pull up waveform?

Thank you,

Best Regards,
Fabio Brina


-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Wed Dec 5 09:07:29 2007

This archive was generated by hypermail 2.1.8 : Wed Dec 05 2007 - 09:08:01 PST