Date: Mon May 18 2009 - 01:37:48 PDT
Hi all. Sorry to bother you. But I have a beginner's question. I didn't find anything in the archive, maybe because it is too simple. I want to do pull up simulation. My Vdd is 3.3V. I understood from the cookbook that V should sweep from -Vdd to 2Vdd relative to VDD. So if I used the circuit below, but its not look reasonable to me, because in this test Vout referring to ground Swing between 0 to 3Vdd and that's mean that the lower ESD diode is not active. So I think that the pull up simulation circuit should look like this: And the Vtable as written in the cookbook should be Vdd(should be always the typ Vdd, am I right?) minus Vout. Thanks. Kobi. -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -------------------------------------------------------------------- |For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org |with the appropriate command message(s) in the body: | | help | subscribe ibis <optional e-mail address, if different> | subscribe ibis-users <optional e-mail address, if different> | unsubscribe ibis <optional e-mail address, if different> | unsubscribe ibis-users <optional e-mail address, if different> | |or e-mail a request to ibis-request@eda-stds.org. | |IBIS reflector archives exist under: | | http://www.eda-stds.org/pub/ibis/email_archive/ Recent | http://www.eda-stds.org/pub/ibis/users_archive/ Recent | http://www.eda-stds.org/pub/ibis/email/ E-mail since 1993
