Subject: RE: [IBIS-Users] FW: Modelling an open drain driver
From: Ingraham, Andrew (Andrew.Ingraham@hp.com)
Date: Thu Nov 21 2002 - 08:54:05 PST
I wrote:
> For R_fixture, using 60 ohms in parallel with Rpullup, would come
> closer
> to the actual circuit. Unless you intended for Rpullup to be on the
> far
> (receiver) end of the 60 ohm trace.
I forgot to say ... you should have a waveform with V_fixture = 0V and
another with V_fixture = Vpullup.
Andy
|------------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with just the appropriate command message(s) in the body:
|
| help
| subscribe ibis <optional e-mail address, if different>
| subscribe ibis-users <optional e-mail address, if different>
| unsubscribe ibis <optional e-mail address, if different>
| unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a written request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
| http://www.eda.org/pub/ibis/email_archive/ Recent
| http://www.eda.org/pub/ibis/users_archive/ Recent
| http://www.eda.org/pub/ibis/email/ E-mail since 1993
This archive was generated by hypermail 2b28 : Thu Nov 21 2002 - 09:06:16 PST