[IBIS-Users] How to include Differential and Non-differential Models in the same file

 Hi,
   I have an input Buffer and I need to devolope IBIS model for this.It
is having
  2 modes
    in MODE_1  it acts as a analog differential input Buffer (A and AZ
are differential                            
       inputs and Y as output).
       MODE_2  it acts as non-differential input Buffer (A is the only
input since AZ must
       be floating and Y is the output).

If I generate models for these how do I include these in a single
component? Why because
  MODE_1 having Pin structure A and AZ along with [Diffpin]  and MODE_2
having Pin structure only A and not [DiffPin].
   And [DiffPin] key word will be having influence on Non-differential
Model i.e MODE_2.

Thanks
Regards
kiran



Confidentiality Notice

The information contained in this electronic message and any attachments to this message are intended
for the exclusive use of the addressee(s) and may contain confidential or privileged information. If
you are not the intended recipient, please notify the sender at Wipro or Mailadmin@wipro.com immediately
and destroy all copies of this message and any attachments.

|------------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with just the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a written request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda.org/pub/ibis/email_archive/  Recent
|  http://www.eda.org/pub/ibis/users_archive/  Recent
|  http://www.eda.org/pub/ibis/email/          E-mail since 1993