[IBIS-Users] how we decide R_fixture of buffer

From: Akhilesh CHANDRA <akhilesh.chandra_at_.....>
Date: Sat Apr 23 2005 - 09:08:52 PDT
Hello Friends,

   I am working on one of my IO design. When I put a transmission line 
with Z0=70ohm and length is 2inch with 5pf load my rise and fall time is 
just 50nsec. When I use R_fixture =70ohm in my design then transition 
time increase to 300nsec. This cause a lot of spice and IBIS mismatch in 
my final models.
  Could you please give me an idea that how we can select a good 
R_fixture value. If you have any doc that help me to understand how we 
can select R_fixture and it's effect in final simulation.
  Customer spec say that this cell is work fine till 10pf load. I don't 
have any R_fixture and V_fixture information from customer.

Regards
Akhilesh


|------------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with just the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a written request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda.org/pub/ibis/email_archive/  Recent
|  http://www.eda.org/pub/ibis/users_archive/  Recent
|  http://www.eda.org/pub/ibis/email/          E-mail since 1993
Received on Sat Apr 23 09:09:16 2005

This archive was generated by hypermail 2.1.8 : Sat Apr 23 2005 - 09:12:37 PDT