[IBIS-Users] Serious Convergence Problem

From: Ratheesh P K <ratheesh_pk_at_.....>
Date: Sat May 07 2005 - 00:49:49 PDT
Hi Experts,

I use Specctraquest for doing SI.
For a particular HSTL i/f running at 125MHz, I get
serious convergence problem for some nets.
I presume this is an issue with the IBIS models (the
driver IBIS model to be precise)

The driver IBIS model in this case is a Broadcom model
- BCM5414. An IBIS check on this model gives warnings
about the AC rising points not within 2% of (x V, y V)
on VI curves.

How do I get rid of the convergence problem ?

Thanks
Ratheesh 


		
__________________________________ 
Yahoo! Mail Mobile 
Take Yahoo! Mail with you! Check email on your mobile phone. 
http://mobile.yahoo.com/learn/mail 
|------------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with just the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a written request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda.org/pub/ibis/email_archive/  Recent
|  http://www.eda.org/pub/ibis/users_archive/  Recent
|  http://www.eda.org/pub/ibis/email/          E-mail since 1993
Received on Sat May 7 00:49:57 2005

This archive was generated by hypermail 2.1.8 : Sat May 07 2005 - 00:51:22 PDT