[IBIS-Users] RE: [IBIS] Warning in LVDS Clamp data

From: Mandel, Cary <cary_mandel_at_.....>
Date: Wed Mar 14 2007 - 04:35:30 PDT
Hello Sudarshan,
 
The 3rd warning means that, a clamp is allowing as much as 1/3 amp of
current to flow, while the voltage is still within the voltage rails.
This is probably not what you intended, unless, you are incorporating
the electrical charactersitics of an on-die-terminator into the clamps.
 
If you would like to discuss this further, I suggest you contact Mentor
directly - you can email me if you like.
 
Cary Mandel
Mentor Graphics
 

________________________________

From: owner-ibis@server.eda.org [mailto:owner-ibis@server.eda.org] On
Behalf Of Sudarshan Honnudike
Sent: 14 March 2007 11:11
To: ibis@server.eda.org; ibis-users@server.eda.org
Subject: [IBIS] Warning in LVDS Clamp data



Hi IBIS Experts, 

One of my customer is getting the following warning in ICX parser. 

;;    ;;   Warning: Current (0.306459) of summed typical power and
ground clamp curves exceed 0.005 amps in the range between power and
ground.
;;    ;;   Warning: Current (0.274468) of summed minimum power and
ground clamp curves exceed 0.005 amps in the range between power and
ground.
;;    ;;   Warning: Current (0.336667) of summed maximum power and
ground clamp curves exceed 0.005 amps in the range between power and
ground.

While running ibischk4 I didnt get this warning. These warnings i am
getting for LVDS input cell. 

Please also let me know what this warning means. 


Best Regards,

Sudarshan HN
NXP Semiconductors/CTO /PLT
C-4, Manyata Tech Park, Nagawara
Bangalore-560 045 , India.    
Ph:+91-80-40267073  
Fax: +91-80-4026 7855
seri:sudarsha@inpsblr
E-mail: sudarshan.honnudike@nxp.com
-- 
This message has been scanned for viruses and 
dangerous content by MailScanner <http://www.mailscanner.info/> , and is

believed to be clean. 

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.


--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Wed Mar 14 04:35:51 2007

This archive was generated by hypermail 2.1.8 : Wed Mar 14 2007 - 04:37:09 PDT