[IBIS-Users] Need help with GND_Clamp and POWER_Clamp

From: Hung Ngo <hngo_at_.....>
Date: Wed May 30 2007 - 15:27:08 PDT
Hello Randy,

I am a beginner at IBIS.  I downloaded the free tools from IBIS homepage 
and try to generate the models for the first time.

So far so good but the example script 
(http://www.vhdl.org/pub/ibis/s2ibis/s2ibis2_v1.1/) does not include 
GND_clamp and POWER_clamp. Is there any other scripts or examples you 
can tell me so I can complete my IBIS models quickly?



My question to you is:

1/ when I sweep the supply range for GND_clamp from -VDD to +VDD, should 
I tie the Pad to VSS or to VDD?
1/ when I sweep the supply range for POWER_clamp from -VDD to 0V, should 
I tie the Pad to VSS or to VDD?

Your help is greatly appreciated.
Thank you Randy.

Hung Ngo
Atrua Technologies
1696 Dell Avenue
Campbell, CA 95008
(408) 370-8015


>  
>

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.



--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Wed May 30 15:27:59 2007

This archive was generated by hypermail 2.1.8 : Wed May 30 2007 - 15:29:06 PDT