[IBIS-Users] Model_selector in S2IBIS3

From: Sudarshan H N <hn.sudarshan_at_.....>
Date: Thu Jan 24 2008 - 05:50:57 PST
Hi,

Is it possible to model "Model_selector" using S2IBIS3 ? I mean if a pad
have different modes of operation may be wrt to drive strength( 5mA, 10mA) ,
is it possible to specify using S2IBIS3 setup ? In that case how do we
control the variables or pins which control the different modes of operation
using single setup file ?

Let me know your answers.

Regards
Sudarshan

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.


--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Thu Jan 24 05:51:34 2008

This archive was generated by hypermail 2.1.8 : Thu Jan 24 2008 - 05:52:39 PST