[IBIS-Users] LVDS RECEIVER Validation

From: Praveen Patel <ppraveen_at_.....>
Date: Sun Feb 17 2008 - 19:55:16 PST
Hello Guys,

   I'm confused while running LVDS Receiver IBIS validation. This
receiver is internally terminated with 100 ohm between non-inverting &
inverting pin. In its IBIS model I have instantiated a [R Series] Model
for this resistor. But when run Hspice simulation, I don't get expected
results. I doubt it is because I'm not calling resistor model in deck
file but calling only Model for inverting & non-inverting pins. 

I don't know to call resistor model in deck file. is there anyway to
call resistor model? Actually I was reading some doc and fount that
Resistor [R Series] model is not supported by some simulator and user
has to put same resistance in deck file manually between those two pins.
I'm not sure if this is true for Hspice also. But when I did so I got
better and expected results.

 

Can someone put some lights on it, what I'm doing is correct or not?

Thanks for your time.. 

 

Thanks & Regds,
-----------------------------------------------
Praveen | Senior Product Engineer
Magma Design Automation | Bangalore, India
Phone: +91 80 4024 2790 | Fax: +91 80 4024 2998 
E-mail: ppraveen@magma-da.com Web: www.magma-da.com

"The Sun never sets on Magma..."

"CONFIDENTIALITY NOTICE: This e-mail may contain information that is
confidential and proprietary to Magma, and Magma hereby designates the
information in this e-mail as confidential. The information is intended
only for the use of the individual or entity named above. If you are not
the intended recipient, you are hereby notified that any disclosure,
copying, distribution or use of any of the information contained in this
transmission is strictly prohibited and that you should immediately
destroy this e-mail and its contents and notify Magma."

 


-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.


--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Sun Feb 17 19:55:49 2008

This archive was generated by hypermail 2.1.8 : Sun Feb 17 2008 - 19:58:28 PST