[IBIS-Users] How to handle > 50% correlation

From: Silva, Estella <Estella.Silva@nsc.com>
Date: Wed Feb 16 2011 - 11:46:05 PST

Hello,

I created an IBIS model of a GPIO cell and correlated the simulation results between using the IBIS model (HSPICE simulation) with the transistor level (spectre simulation).

I used two methods in obtaining the IV and VT curves.

However, the correlation results are 50% off for the risetimes & falltimes for both cases.

Can anyone please advise on what to do in this case?

Thanks & best regards,
Estella

National Semiconductor
(408) 721-7678

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Wed Feb 16 11:46:46 2011

This archive was generated by hypermail 2.1.8 : Wed Feb 16 2011 - 11:47:26 PST