[IBIS-Users] RE: Regarding IBIS Model

Sandeep,

As far as I know, the only way you can check
whether an IBIS model is working or not is by
putting a test circuit together in your favorite
EDA tool and run a few test simulations.

Thanks,

Arpad
=================================================

From: owner-ibis-users@eda.org [mailto:owner-ibis-users@eda.org] On Behalf Of Sandeep Kumar(Sandeep Kumar)/Engineer I (??)/MSI.Engineering/(?)??
Sent: Thursday, December 12, 2013 9:37 PM
To: ibis-users@eda.org
Subject: [IBIS-Users] Regarding IBIS Model

Hi ,

I want to know is there any method to know to check whether IBIS model is working or  not except
manual Verification.

Thanks & Regards
Sandeep Kumar


--
This message has been scanned for viruses and
dangerous content by MailScanner<http://www.mailscanner.info/>, and is
believed to be clean.

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.


--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail mikelabonte@eda-stds.org
|or ibis-request@eda-stds.org
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/ibis/email_archive/ Recent
|  http://www.eda-stds.org/ibis/users_archive/ Recent
|  http://www.eda-stds.org/ibis/email/         E-mail since 1993