Pin to model mapping

From: John Berrie <johnb@redac.co.uk>
Date: Tue Feb 03 1998 - 04:09:48 PST

Hello IBISers,
Since we are currently in the process of constructing an IBIS extractor,
it would be really useful if someone could answer the following question:

In some of the IBIS part models on the web site, there is an incomplete
mapping of pins to driver and receiver models.

1. Is this intentional?
2. Is there a default mapping which takes place if a pin within a part
   does not have an eplicit mapping?

One of the parts only had two pin mappings, even though the part has
more than 14 pins, and multiple drivers/receivers (a buffer chip).

Thank you in advance
John

John Berrie
Chief Application Engineer
Dynamic Solutions
Zuken-Redac
Tewkesbury
U.K.

 
Received on Tue Feb 3 04:01:57 1998

This archive was generated by hypermail 2.1.8 : Fri Jun 03 2011 - 09:53:46 PDT