RE: IBIS connector model

I believe this error is due to the "pinuse" property of your connector pins in the Allegro symbol for the connector. You need to
set the property to "unspec" on all connector pins.

-----Original Message-----
From: Kanal_Bashu@emc.com [mailto:Kanal_Bashu@emc.com]
Sent: Monday, May 22, 2000 7:40 AM
To: ibis-users@eda.org
Subject: IBIS connector model

I am trying to extract a topology using SpectraQuest, but cannot because
of the following error. "Errors: Connector With Active pin". The model is
attached to this message. Can anyone clarify the proper use of connector
models in circuit simulation or provide me with a connector model?

Regards,

Bashu Kanal
EMC Corporation
Design Verification Group
 <<conn149.ibs>>
Received on Mon May 22 06:44:52 2000