Hirut:
The Series and Series Switch models must be positioned under the
[Series Pin Mapping] keyword to document connections between
two pins. The other types of models still are put under the [Pin]
keyword. Input or Output models can be attached to the same pin
as Series models.
Bob Ross
Mentor Graphics
hasf@us.ibm.com wrote:
> Hi All,
> I was having trouble using a particular keyword that is not supported
> in a certain model_type. For example, the [R Series] keyword is supported
> for a model_type "Series" , but not for "Input" model_types. At the same
> time, POWER/GND clamps are not supporeted under a "Series" model_type
> model. Is there a way to manipulate that? Maybe by calling another
> [Submodel] within the top level model and specify that as a "Series"
> submodel_type. I've tried it but wasn't successful.
>
> Regards,
> Hirut
>
> Hirut Asfaw
> ASIC I/O Developement
> IBM Microelectronics Division
> External: (802) 769-0652 T/L: 6-0652
> hasf@us.ibm.com
Received on Wed Mar 21 23:32:53 2001
This archive was generated by hypermail 2.1.8 : Fri Jun 03 2011 - 09:53:47 PDT