Subject: RE: [IBIS-Users] IBIS website (Question, Internal 100 Ohms termination)
From: Lynne Green (lgreen@cadence.com)
Date: Thu May 01 2003 - 14:28:18 PDT
Hi, Gus,
Not sure which version of ibischk3 you ran. But problem might be one of
the
bugs in ibischk3 version 3.2.8 which was fixed in version 3.2.9.
>> ERROR - Component 'XXXX': [Series Pin Mapping] Pin2 '17': model type
cannot be Series or Series_switch.
Also, you might want to consider submitting this model to the IBIS Model
Review Committee.
http://www.eigroup.org/ibis/support.htm
Cheers,
Lynne
Dr. Lynne Green
Senior Member of Consulting Staff
Cadence Design Systems, Inc.
"Digital is analog that you hope is in one of two states."
|------------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with just the appropriate command message(s) in the body:
|
| help
| subscribe ibis <optional e-mail address, if different>
| subscribe ibis-users <optional e-mail address, if different>
| unsubscribe ibis <optional e-mail address, if different>
| unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a written request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
| http://www.eda.org/pub/ibis/email_archive/ Recent
| http://www.eda.org/pub/ibis/users_archive/ Recent
| http://www.eda.org/pub/ibis/email/ E-mail since 1993
This archive was generated by hypermail 2b28 : Thu May 01 2003 - 14:33:00 PDT