[IBIS-Users] on-die termination ... one more time

Hi all, 

    Thank you by your answers. I am generating an IBIS model that includes 
an input structure with a pull-up resistor. I include the pull-up resistor 
characteristics in the ground clamp curve but when I check the IBIS file 
with IBIS parser (IBISCHK3 v3.2.9) the parser  gives the warning: “WARNING – 
Model Input02: GND Clamp : Maximum value never becomes zero”.
    Michael Mirmak said that there is no requirement for all clamp curves to 
“reach the zero value” then what is the cause for this Warning? 

                                      Thank you 

Best Regards 

Ramiro
|------------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with just the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a written request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda.org/pub/ibis/email_archive/  Recent
|  http://www.eda.org/pub/ibis/users_archive/  Recent
|  http://www.eda.org/pub/ibis/email/          E-mail since 1993