[IBIS-Users] Modeling Diff Buffers

From: Anguraj K <b05108_at_.....>
Date: Fri Feb 02 2007 - 02:30:14 PST
Hi Experts,
Could you please answer my below questions?

1. If vdiff value varies for diff pins (due to diff modes of operation, 
namely speed), How do I define that in IBIS models.
Through [Diff Pin] keyword, we can pass only one value to vdiff.

2. How to define common mode value in the diff signals? (I believe there 
are other IBIS users who raised the same question some time earlier)

3. When measuring C-Comp for drivers,
I see three main variables on which die cap depends on.
1. Freq of operation
2. Data value (0 to vdd) to be sent
3. Process corners

I vary these three variables and finding the max and min value for 
C_comp. Is that right?
But,  I usually see very huge die-cap for the drivers(unrealistic)






-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Fri Feb 2 02:34:44 2007

This archive was generated by hypermail 2.1.8 : Fri Feb 02 2007 - 02:36:22 PST