Hello, I downloaded new s2ibis3 from the site http://www.ece.ncsu.edu/erl/ibis/s2ibis3/s2ibis3.htm and tried using it. I was able generate IBIS models with the example given in that link. But i am not able to generate separate IBIS models for the spice models . While providing input to *.s2i file i have the following queries. 1. If the IO spice netlist contains all the IO pad netlists in a single file , how to give the only those IO pad names that i wish to model it. 2. In the process model file, if all the typical, min and max corner definitions are present in a single file, how do we separately mention process models for each corner. eg: .lib '/home/sudarshann/ibis/S2IBIS/new/tsl018.lib' ff_hv for fast corner .lib '/home/sudarshann/ibis/S2IBIS/new/tsl018.lib' ss_hv for slow corner How can i achieve such kind of constructs in S2IBIS setup file . 3. How can i mention the separate voltage levels for each pin. For example how can i specify , say 1.2V on Input and enable pins and 3.3V on PAD pins. Let me know your answers. Regards Sudarshan -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -------------------------------------------------------------------- |For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org |with the appropriate command message(s) in the body: | | help | subscribe ibis <optional e-mail address, if different> | subscribe ibis-users <optional e-mail address, if different> | unsubscribe ibis <optional e-mail address, if different> | unsubscribe ibis-users <optional e-mail address, if different> | |or e-mail a request to ibis-request@eda-stds.org. | |IBIS reflector archives exist under: | | http://www.eda-stds.org/pub/ibis/email_archive/ Recent | http://www.eda-stds.org/pub/ibis/users_archive/ Recent | http://www.eda-stds.org/pub/ibis/email/ E-mail since 1993Received on Tue Nov 13 22:27:55 2007
This archive was generated by hypermail 2.1.8 : Tue Nov 13 2007 - 22:29:05 PST