RE: [IBIS-Users] Non-existence of C_load in [Ramp] keyword

Just anther point in addition to all the
previous responses:
 
The ramp information does not have to be
based on a waveform that is in one of the
V-t tables...
 
Arpad
=========================================

________________________________

From: owner-ibis-users@eda.org [mailto:owner-ibis-users@eda.org] On
Behalf Of surendra.deshmukh@wipro.com
Sent: Thursday, September 16, 2010 6:56 AM
To: ibis-users@eda.org
Subject: [IBIS-Users] Non-existence of C_load in [Ramp] keyword

Hi,

    The [Ramp] keyword used in IBIS initial version is still there in
new versions along with VT tables. This Ramp keyword also gives Rload
value.

 My question is as far as these VT tables are calculated only for
Rixture (or Rload), simulator has a choice to take value from [Ramp]
keyword without any problem but if these tables are generated for
Rfixture and C_fixture values (non-zero C_fixture value) then there is
no any keyword C_load inside the [Ramp] section.

        How the simulator handles this case where [Ramp] is calculated
for Rfixture and C_fixture but there is no any C_load keyword in ramp
section? Does [Ramp] require any C_load keyword?

Regards

Surendra

Please do not print this email unless it is absolutely necessary.

The information contained in this electronic message and any attachments
to this message are intended for the exclusive use of the addressee(s)
and may contain proprietary, confidential or privileged information. If
you are not the intended recipient, you should not disseminate,
distribute or copy this e-mail. Please notify the sender immediately and
destroy all copies of this message and any attachments.

WARNING: Computer viruses can be transmitted via email. The recipient
should check this email and any attachments for the presence of viruses.
The company accepts no liability for any damage caused by any virus
transmitted by this email.

www.wipro.com

-- 
This message has been scanned for viruses and 
dangerous content by MailScanner <http://www.mailscanner.info/> , and is
believed to be clean. 
-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993