[IBIS-Users] C_compy_pullup/puldown/clamp advanced parameters for IBIS model simulation

Hi All,

Can somebody share any experience of using advanced C_comp_pullup/puldown/.. parameters in IBIS models?
Is it any significant/valuable impact on IBIS Models simulation results (waveforms)?
Some specific test load (circuit)? Transmission lane? Non-Ideal Power/Ground sources? Else?
Any particular guidelines, details for support/implementation of these parameters in Simulator?

I will appreciate any notes, information for questions above.

If there any concerns for particular tool name/company trademarks - feel free contact me directly:

Sergey.Nikonchuk@freescale.com<mailto:Sergey.Nikonchuk@freescale.com>

Thank You in advise,
Sergey.

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993