Sandeep, As far as I know, the only way you can check whether an IBIS model is working or not is by putting a test circuit together in your favorite EDA tool and run a few test simulations. Thanks, Arpad ================================================= From: owner-ibis-users@eda.org [mailto:owner-ibis-users@eda.org] On Behalf Of Sandeep Kumar(Sandeep Kumar)/Engineer I (??)/MSI.Engineering/(?)?? Sent: Thursday, December 12, 2013 9:37 PM To: ibis-users@eda.org Subject: [IBIS-Users] Regarding IBIS Model Hi , I want to know is there any method to know to check whether IBIS model is working or not except manual Verification. Thanks & Regards Sandeep Kumar -- This message has been scanned for viruses and dangerous content by MailScanner<http://www.mailscanner.info/>, and is believed to be clean. -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -------------------------------------------------------------------- |For help or to subscribe/unsubscribe, e-mail mikelabonte@eda-stds.org |or ibis-request@eda-stds.org | |IBIS reflector archives exist under: | | http://www.eda-stds.org/ibis/email_archive/ Recent | http://www.eda-stds.org/ibis/users_archive/ Recent | http://www.eda-stds.org/ibis/email/ E-mail since 1993Received on Thu Dec 19 20:10:56 2013
This archive was generated by hypermail 2.1.8 : Thu Dec 19 2013 - 20:11:36 PST