Re: question about IBIS versions

Kim:

In general, the Version of IBIS needs to be brought up to
the level of the highest version keyword or sub-parameter
within the file. This will allow it to pass ibischk3 at
the proper version level (which could be 1.1, 2.1 or 3.2).
In your case, just changing the Version number to 3.2 should
be sufficient when adding [Model Selector].

Because of the upward compatibility goal, no other changes
are necessary.

Bob Ross
Mentor Graphics

Kim Helliwell wrote:
>
> I have a situation where an IBIS model that was made with s2ibis2, and
> is therefore ostensibly a Version 2.1 model, may need a model selector
> keyword.
>
> The question is: is changing the version to 3.x and adding the model selector
> sufficient, or are there actual changes in the syntax of stuff that's common
> between 2.1 and 3.x?
>
> Or are there any other pitfalls in what I'm attempting here?
>
> --
> Kim Helliwell
> Senior CAE Engineer
> Acuson Corporation
> Phone: 650 694 5030 FAX: 650 943 7260
 
 
Received on Tue Oct 31 15:23:00 2000