Subject: [IBIS] about Vref
From: Lior Aviv (RM18440@email.sps.mot.com)
Date: Tue Apr 29 2003 - 07:44:12 PDT
Hello,
I have IO that works with 3.3v +-10%.
The output resistance is 50 Ohm.
My questions are regarding the Vref parameter -
1. Who should set it and how?
2. While running the ibis checker3, I have noticed that there is a
relation
between the Vref and the Vmeas but could not understand what does
the
checker exactly check with these parameters.
The warnings I get are not so clear -
" Model 'xxx': MIN VI curves cannot drive through Vmeas=1.5V
given load Rref=50 Ohms to Vref=zzzV ".
Thanks,
Lior Aviv,
MSIL.
-----------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with the appropriate command message(s) in the body:
|
| help
| subscribe ibis <optional e-mail address, if different>
| subscribe ibis-users <optional e-mail address, if different>
| unsubscribe ibis <optional e-mail address, if different>
| unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
| http://www.eda.org/pub/ibis/email_archive/ Recent
| http://www.eda.org/pub/ibis/users_archive/ Recent
| http://www.eda.org/pub/ibis/email/ E-mail since 1993
This archive was generated by hypermail 2b28 : Tue Apr 29 2003 - 07:51:07 PDT