[IBIS] Pull Down data

From: lau yy <tok47_at_.....>
Date: Tue Mar 07 2006 - 04:45:50 PST
Hi ALL,
 
 
I have some question regading the Pull Down datas.
 
The data for my I/O pin start from 0 then decrease (become negative value), but suddenly the data turn to positive value (in mV). Anything wrong with these datas?
 
And when I check these data by using ibischk3, I have the mismatch problem. Is this cause by the Pull Down datas? Is this a design problem or simulator problem?
 
I do attach the IBIS model with this mail.
 
Thanks
 
rdgs
yylau
-----------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda.org/pub/ibis/email_archive/  Recent
|  http://www.eda.org/pub/ibis/users_archive/  Recent
|  http://www.eda.org/pub/ibis/email/          E-mail since 1993
Received on Tue Mar 7 04:46:03 2006

This archive was generated by hypermail 2.1.8 : Tue Mar 07 2006 - 04:54:31 PST