[IBIS] How to connect single pin to multiple pads in IBIS

From: Sudarshan Honnudike <sudarshan.honnudike_at_.....>
Date: Fri Apr 20 2007 - 02:20:18 PDT
Hello Everybody,

One of my customer is facing problem with the connecting a single pin to 
multiple pads(different models). 
Actually he is connecting an analog cell and output cell to a single pin 
on the package. How this has to be
done in [pin] section of IBIS ? How to associate 2 models for single pin 
in IBIS ?

Let me know your response.

Best Regards,

Sudarshan HN
NXP Semiconductors/CTO /PLT
C-4, Manyata Tech Park, Nagawara
Bangalore-560 045 , India. 
Ph:+91-80-40247073 
Fax: +91-80-4026 7855
seri:sudarsha@inpsblr
E-mail: sudarshan.honnudike@nxp.com
-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.


--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Fri Apr 20 02:19:10 2007

This archive was generated by hypermail 2.1.8 : Fri Apr 20 2007 - 02:20:52 PDT