RE: [IBIS] About Fork in The Package Model

Hello, Yasser,

FORK and ENDFORK not allowed in PKG models.
FORK and ENDFORK are allowed in EBD and ICM models.

- Lynne 


"IBIS training when you need it, where you need it."

Dr. Lynne Green
Green Streak Programs
http://www.greenstreakprograms.com
425-788-0412
lgreen22@mindspring.com

-----Original Message-----
From: owner-ibis@eda.org [mailto:owner-ibis@eda.org] On Behalf Of Yasser
Sabry
Sent: Sunday, May 06, 2007 9:11 AM
To: ibis@eda-stds.org
Subject: [IBIS] About Fork in The Package Model

Hi all,

Fork is used to make branches. In EBD, it is clear where these branches go
to as the destination node or pin is specified. However, in package model
the destination is not clear for me. Where do the branches go to?

Thanks for your help,
Yasser Sabry

-------------------------------------------
Yasser Mohammed Sabry
Device Modeling Team
Analog/Mixed Signal - DSM Division
Mentor Graphics Egypt
Tel: (+202) 416 3613
Mob: (+2010) 1834833
Fax: (+202) 418 6945
E-mail: yasser_sabry@mentor.com
-------------------------------------------




-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993