Re: [IBIS] Adding Submodel for a Terminator

From: Bob Ross <bob_at_.....>
Date: Sun May 27 2007 - 22:36:21 PDT
Hi Yasser:

Yes, the submodel is permitted for a Terminator.  Series and Series_switch
model types are the only ones specifically excluded.

Bob

Yasser Sabry wrote:
> Hi all,
> 
> I just want to know if it is permitted to add submodel for a terminator 
> or not?
> If yes, the mode must be non driving. Correct?
> 


-- 
Bob Ross
Teraspeed Consulting Group LLC     Teraspeed Labs
121 North River Drive              13610 SW Harness Lane
Narragansett, RI 02882             Beaverton, OR 97008
401-284-1827                       503-430-1065
http://www.teraspeed.com           503-246-8048 Direct
bob@teraspeed.com

Teraspeed is a registered service mark of Teraspeed Consulting Group LLC


-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Sun May 27 22:36:04 2007

This archive was generated by hypermail 2.1.8 : Sun May 27 2007 - 22:37:05 PDT