Hi, Can somebody explain me the usage of V-T curves in IBIS simulations at the board level. While generating V-T curves we assume some resistive load (say 50ohm) and give the rising and falling waveforms. But the actual board might see the different RLC values . How does the tool interpolate or extrapolate these curves to get the exact waveforms at the driver output for the given load with just one table of V-T curves. ? Regards Sudarshan -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -------------------------------------------------------------------- |For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org |with the appropriate command message(s) in the body: | | help | subscribe ibis <optional e-mail address, if different> | subscribe ibis-users <optional e-mail address, if different> | unsubscribe ibis <optional e-mail address, if different> | unsubscribe ibis-users <optional e-mail address, if different> | |or e-mail a request to ibis-request@eda-stds.org. | |IBIS reflector archives exist under: | | http://www.eda-stds.org/pub/ibis/email_archive/ Recent | http://www.eda-stds.org/pub/ibis/users_archive/ Recent | http://www.eda-stds.org/pub/ibis/email/ E-mail since 1993Received on Mon Aug 4 01:04:32 2008
This archive was generated by hypermail 2.1.8 : Mon Aug 04 2008 - 01:05:24 PDT