[IBIS] How to model current interfaces like SWP ?

From: Christian Sporrer Dr. <christian.sporrer@infineon.com>
Date: Tue Jul 17 2012 - 00:34:31 PDT

Hello IBIS gurus,

we need some information how to model a current
interface (SWP, single wire protocol).
The problem is, that there is nearby no voltage
swing at the driver output. Only the amount of
current is switching. The IBIS waveforms
support only voltage waveforms. How can we
model current waveforms?

Thanks,

Christian & Matthias.

-- 
Infineon Technologies AG
Vorsitzender des Aufsichtsrats: Wolfgang Mayrhuber
Vorstand: Peter Bauer (Vorsitzender), Dominik Asam,
Arunjai Mittal, Dr. Reinhard Ploss
Sitz der Gesellschaft: Neubiberg
Registergericht: München, HRB 126492

--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
| help
| subscribe ibis <optional e-mail address, if different>
| subscribe ibis-users <optional e-mail address, if different>
| unsubscribe ibis <optional e-mail address, if different>
| unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
| http://www.eda-stds.org/pub/ibis/email_archive/ Recent
| http://www.eda-stds.org/pub/ibis/users_archive/ Recent
| http://www.eda-stds.org/pub/ibis/email/ E-mail since 1993

Received on Tue Jul 17 00:34:35 2012

This archive was generated by hypermail 2.1.8 : Tue Jul 17 2012 - 00:35:00 PDT