[IBIS-Users] measured on the bench

From: lau yy <tok47_at_.....>
Date: Thu May 04 2006 - 06:06:57 PDT
Hi ALL,
 
Regarding the tittle above, I wish to know that what should I need if I want to measurement the V/I from a package unit/ bare die?
 
The main reason I do this is because I need to valiidate for the accuracy of IBIS model that I built.
 
Is it a normal tester already can do it? or I need some special equipment or software?
 
Do there any document regading this?
 
Thanks in advanced.
 
rdgs
tok
|------------------------------------------------------------------ |For help or to subscribe/unsubscribe, email majordomo@eda.org |with just the appropriate command message(s) in the body: | | help | subscribe ibis | subscribe ibis-users | unsubscribe ibis | unsubscribe ibis-users | |or email a written request to ibis-request@eda.org. | |IBIS reflector archives exist under: | | http://www.eda.org/pub/ibis/email_archive/ Recent | http://www.eda.org/pub/ibis/users_archive/ Recent | http://www.eda.org/pub/ibis/email/ E-mail since 1993 Received on Thu May 4 06:07:02 2006

This archive was generated by hypermail 2.1.8 : Thu May 04 2006 - 06:08:01 PDT