Hi Xuefeng: We intended that if there the Matrix uses the keyword [Frequency], then all the matricies specified including the [Resistance Matrix] have data sets at each of the specified frequencies. This keeps all of the matrix data aligned and explicitly specified for each frequency. We chose to be inflexable and not support arbitraily different frequencies for different matrices or a single matrix with no frequency variation when other matrices have frequency variations. Even resistance and conductance matrix elements can vary with frequency. So the error message is correct and complies with the the specification. Best Regards, Bob Xuefeng Chen wrote: > Hi Expert, > > I found for frequency dependent Matrix where [Frequency] is omitted > only in [Resistance Matrix](like Matrix Example in IIRD2.3), ICMCHK1 > will report bellow error. > > ERROR:'[Resistance Matrix]' does not have the same number of > frequencies as '[Inductance Matrix]' > > > > ICM1.1 spec. tell us that ?If a matrix keyword, such as > [Resistance Matrix] etc., is used > > in combination with one or more [Frequency] keyword data sets, all other > matrix keywords, if present and consisting of non-zero > frequency-dependent data, must contain [Frequency] data sets at the same > frequency points.? > > > > So is it a bug? > > Thanks for any input! > > > > Best regards > > Xuefeng > -- Bob Ross Teraspeed Consulting Group LLC Teraspeed Labs 121 North River Drive 13610 SW Harness Lane Narragansett, RI 02882 Beaverton, OR 97008 401-284-1827 503-430-1065 http://www.teraspeed.com 503-246-8048 Direct bob@teraspeed.com Teraspeed is a registered service mark of Teraspeed Consulting Group LLC -------------------------------------------------------------------- |For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org |with the appropriate command message(s) in the body: | | help | subscribe ibis <optional e-mail address, if different> | subscribe ibis-users <optional e-mail address, if different> | unsubscribe ibis <optional e-mail address, if different> | unsubscribe ibis-users <optional e-mail address, if different> | |or e-mail a request to ibis-request@eda-stds.org. | |IBIS reflector archives exist under: | | http://www.eda-stds.org/pub/ibis/email_archive/ Recent | http://www.eda-stds.org/pub/ibis/users_archive/ Recent | http://www.eda-stds.org/pub/ibis/email/ E-mail since 1993Received on Wed Nov 8 16:01:03 2006
This archive was generated by hypermail 2.1.8 : Wed Nov 08 2006 - 16:02:14 PST