[IBIS-Users] Dynamic behaviour of buffer

Hello Experts,

I have a driver with Slope control circuit at output pin. This circuit
controls driver behaviour according to the Load on output pin.

IBIS model of this buffer has only R_fixture but when I am simulating IBIS
model with certain capacitive load then IBIS is not able to produce exact
SPICE behaviour.

My observation for mismatch is dynamic behavior of Slope control circuit
with load which I am not able to model in IBIS.

My question is how can I model the dynamic behaviour of Slope control
circuit in IBIS ?

Regards
Prabhat

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.


--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993