[IBIS-Users] Regarding data extraction method for [ISSO_PU], ibis spec ver.5.0

From: Vipul Pursottam PATEL <vipul.patel_at_.....>
Date: Fri Sep 18 2009 - 03:15:03 PDT
Hello Experts,

While going through IBIS specs 5.0, I found some discrepancy in the
description of [ISSO_PU] keyword on page no. 59 (PDF version). Here in the 
Last says "The output is connected to the Vcc (typical) value as shown
below." , but in the figure the output is shown connected to GND (PullDown
reference). 
I think the output should be connected to GND for extraction of data for
[ISSO_PU] keyword which is shown in the fig on page 60.

Regards,
Vipul Patel



-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.



--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Fri Sep 18 03:16:03 2009

This archive was generated by hypermail 2.1.8 : Fri Sep 18 2009 - 03:17:34 PDT