Subject: [IBIS] Rsing/Falling/Ramp
From: Shee Kian Wong (SKWONG@altera.com)
Date: Wed Dec 04 2002 - 18:59:58 PST
Hi all,
Normally there are 2 sets of rising/falling (1 set for 50W to gnd and 1 set
for 50W to vcc) plus 1 ramp data in an IBIS file.
Which one does a simulator use? The ramp or the rising/falling data? If
rising/ falling data is used, which set (there are normally >1 set of data)
would be chosen?
Rgds,
Shee Kian
-----------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with the appropriate command message(s) in the body:
|
| help
| subscribe ibis <optional e-mail address, if different>
| subscribe ibis-users <optional e-mail address, if different>
| unsubscribe ibis <optional e-mail address, if different>
| unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
| http://www.eda.org/pub/ibis/email_archive/ Recent
| http://www.eda.org/pub/ibis/users_archive/ Recent
| http://www.eda.org/pub/ibis/email/ E-mail since 1993
This archive was generated by hypermail 2b28 : Wed Dec 04 2002 - 19:18:09 PST