[IBIS] About Fork in The Package Model

From: Yasser Sabry <yasser_sabry_at_.....>
Date: Sun May 06 2007 - 09:11:07 PDT
Hi all,

Fork is used to make branches. In EBD, it is clear where these branches 
go to as the destination node or pin is specified. However, in package 
model the destination is not clear for me. Where do the branches go to?

Thanks for your help,
Yasser Sabry

-------------------------------------------
Yasser Mohammed Sabry
Device Modeling Team  
Analog/Mixed Signal - DSM Division
Mentor Graphics Egypt
Tel: (+202) 416 3613
Mob: (+2010) 1834833
Fax: (+202) 418 6945
E-mail: yasser_sabry@mentor.com
-------------------------------------------




-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Sun May 6 09:11:04 2007

This archive was generated by hypermail 2.1.8 : Sun May 06 2007 - 09:12:21 PDT