[IBIS] Adding Submodel for a Terminator

From: Yasser Sabry <yasser_sabry_at_.....>
Date: Sun May 27 2007 - 01:05:39 PDT
Hi all,

I just want to know if it is permitted to add submodel for a terminator 
or not?
If yes, the mode must be non driving. Correct?

-- 

Thank you and Best Regards,
Yasser Sabry

-------------------------------------------
Yasser Mohammed Sabry
Device Modeling Team  
Analog/Mixed Signal - DSM Division
Mentor Graphics Egypt
Tel: (+202) 416 3613
Mob: (+2010) 1834833
Fax: (+202) 418 6945
E-mail: yasser_sabry@mentor.com
-------------------------------------------




-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Sun May 27 01:05:31 2007

This archive was generated by hypermail 2.1.8 : Sun May 27 2007 - 01:07:44 PDT