Dear All, It is assumed that Ids=0 for Vds=0 in series MOSFET According to that, both interpolation and extrapolation can be done even if the IBIS file contains one Ids-Vgs table at a given Vds However, we found that the parser accepts this one Ids_Vgs table to be given at Vds=0 Is that right? Thank you and Best Regards, Yasser Sabry ------------------------------------------- Yasser Mohammed Sabry Device Modeling Team Analog/Mixed Signal - DSM Division Mentor Graphics Egypt Tel: (+202) 416 3613 Mob: (+2010) 1834833 Fax: (+202) 418 6945 E-mail: yasser_sabry@mentor.com ------------------------------------------- -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -------------------------------------------------------------------- |For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org |with the appropriate command message(s) in the body: | | help | subscribe ibis <optional e-mail address, if different> | subscribe ibis-users <optional e-mail address, if different> | unsubscribe ibis <optional e-mail address, if different> | unsubscribe ibis-users <optional e-mail address, if different> | |or e-mail a request to ibis-request@eda-stds.org. | |IBIS reflector archives exist under: | | http://www.eda-stds.org/pub/ibis/email_archive/ Recent | http://www.eda-stds.org/pub/ibis/users_archive/ Recent | http://www.eda-stds.org/pub/ibis/email/ E-mail since 1993Received on Thu Aug 2 01:00:27 2007
This archive was generated by hypermail 2.1.8 : Thu Aug 02 2007 - 01:01:45 PDT