Sir, As i said before our products are oscillators where we need to give the temperature range where oscillators are stable. Till date we haven't done any IBIS model for our oscillators and we do not have any software or hardware for IBIS model generation. Our clients need IBIS model. Our oscillator have two supply pins(V_control and Vcc) and one ground pin and one frequency output pin in general. Voltage range for this is generally 2.5volts for voltage control and Vcc is from 3.3v to 12Volts. So can you please tell me the circuit setup required for this and also software available for the IBIS model generation. Suggest me the ESD diodes and MOSFET transistors needed and setup required for this. Suggest me what method we can go (spice design or lab method) Regards, Jagadeesh. Forgot the famous last words? Access your message archive online at http://in.messenger.yahoo.com/webmessengerpromo.php -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -------------------------------------------------------------------- |For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org |with the appropriate command message(s) in the body: | | help | subscribe ibis <optional e-mail address, if different> | subscribe ibis-users <optional e-mail address, if different> | unsubscribe ibis <optional e-mail address, if different> | unsubscribe ibis-users <optional e-mail address, if different> | |or e-mail a request to ibis-request@eda-stds.org. | |IBIS reflector archives exist under: | | http://www.eda-stds.org/pub/ibis/email_archive/ Recent | http://www.eda-stds.org/pub/ibis/users_archive/ Recent | http://www.eda-stds.org/pub/ibis/email/ E-mail since 1993Received on Thu Nov 15 21:12:07 2007
This archive was generated by hypermail 2.1.8 : Thu Nov 15 2007 - 21:13:25 PST