[IBIS] Use of Rref declaration in differential signals

From: Shrikant G Kadadevar <Shrikant.G.Kadadevar_at_.....>
Date: Tue Mar 25 2008 - 00:19:00 PDT
Hello All,

Suppose I am using the differential receiver and has the  input 
termination resistor of 100Ohm at the input.
And suppose we have mentioned the Rref as 50Ohm (Rload/2) and R_load as 
50Ohm.
During the validation are we suppose to still add the 100Ohm at the 
input of the receiver or Rref takes care for it.

How actually Rref and R_load differ.

Thanking you
Shrikant GK 
 


-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993
Received on Tue Mar 25 00:45:55 2008

This archive was generated by hypermail 2.1.8 : Tue Mar 25 2008 - 00:47:12 PDT