You could consider using the "Terminator" model type. Arpad ============================= ________________________________ From: owner-ibis@server.eda.org [mailto:owner-ibis@server.eda.org] On Behalf Of Ajay Kapoor Sent: Wednesday, May 21, 2008 12:48 AM To: ibis@server.eda.org; ibis-users@server.eda.org Subject: [IBIS] IBIS for pad with ESD Clamps Dear Experts, I have a question regarding IBIS models. We have an IP that is just a short with only ESD diodes connected between supply rails. There is no input or output section in this IP. Would it be possible to generate IBIS models for such an IP ? If yes how should it be done ? Thanks Ajay -- This message has been scanned for viruses and dangerous content by MailScanner <http://www.mailscanner.info/> , and is believed to be clean. -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -------------------------------------------------------------------- |For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org |with the appropriate command message(s) in the body: | | help | subscribe ibis <optional e-mail address, if different> | subscribe ibis-users <optional e-mail address, if different> | unsubscribe ibis <optional e-mail address, if different> | unsubscribe ibis-users <optional e-mail address, if different> | |or e-mail a request to ibis-request@eda-stds.org. | |IBIS reflector archives exist under: | | http://www.eda-stds.org/pub/ibis/email_archive/ Recent | http://www.eda-stds.org/pub/ibis/users_archive/ Recent | http://www.eda-stds.org/pub/ibis/email/ E-mail since 1993Received on Wed May 21 10:45:37 2008
This archive was generated by hypermail 2.1.8 : Wed May 21 2008 - 10:47:23 PDT