[IBIS] Usage of V-T curves

Hi,

Can somebody explain me the usage of V-T curves in IBIS simulations at the
board level. While generating V-T curves we assume some resistive load (say
50ohm) and give the rising and falling waveforms. But the actual board might
see the different RLC values . How does the tool interpolate or extrapolate
these curves to get the exact waveforms at the driver output for the given
load with just one table of V-T curves. ?

Regards
Sudarshan

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.


--------------------------------------------------------------------
|For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org
|with the appropriate command message(s) in the body:
|
|  help
|  subscribe   ibis       <optional e-mail address, if different>
|  subscribe   ibis-users <optional e-mail address, if different>
|  unsubscribe ibis       <optional e-mail address, if different>
|  unsubscribe ibis-users <optional e-mail address, if different>
|
|or e-mail a request to ibis-request@eda-stds.org.
|
|IBIS reflector archives exist under:
|
|  http://www.eda-stds.org/pub/ibis/email_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/users_archive/ Recent
|  http://www.eda-stds.org/pub/ibis/email/         E-mail since 1993