Hello Experts, While going through IBIS specs 5.0, I found some discrepancy in the description of [ISSO_PU] keyword on page no. 59 (PDF version). Here in the Last says "The output is connected to the Vcc (typical) value as shown below." , but in the figure the output is shown connected to GND (PullDown reference). I think the output should be connected to GND for extraction of data for [ISSO_PU] keyword which is shown in the fig on page 60. Regards, Vipul Patel -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -------------------------------------------------------------------- |For help or to subscribe/unsubscribe, e-mail majordomo@eda-stds.org |with the appropriate command message(s) in the body: | | help | subscribe ibis <optional e-mail address, if different> | subscribe ibis-users <optional e-mail address, if different> | unsubscribe ibis <optional e-mail address, if different> | unsubscribe ibis-users <optional e-mail address, if different> | |or e-mail a request to ibis-request@eda-stds.org. | |IBIS reflector archives exist under: | | http://www.eda-stds.org/pub/ibis/email_archive/ Recent | http://www.eda-stds.org/pub/ibis/users_archive/ Recent | http://www.eda-stds.org/pub/ibis/email/ E-mail since 1993Received on Fri Sep 18 03:16:06 2009
This archive was generated by hypermail 2.1.8 : Fri Sep 18 2009 - 03:17:01 PDT