<Just adding another group> Thanks Abhishek Goswami Phone No -07829580867/9962270999 Skype : abhishekgoswami1 ----- Forwarded Message ----- From: abhishek goswami <zeal_goswami@yahoo.com> To: "ibis-users@eda.org" <ibis-users@eda.org> Sent: Tuesday, 16 December 2014 4:20 PM Subject: Regarding VT Clipping Hi,I am working in hosue tool which generate IBIS File. During the creation of IBIS File, it clip data point from simulation file and write into IBIS File. The Algo for clipping data point from simulation file, we take start point and end point (IV curve pullup and pulldown) and search close point into rise_gnd,rise_sup,fall_gnd,fall_supwaveform simulation data.it's work fine but I am getting 3.2% error with respective to end voltage for rise_gnd min waveform during validation of ibis file. My question is, Do we have any algo/tool which provide VT clipping info. As min corner has some delay in comparison to Typ and Max. How can I handle such delay in IBIS file.I do not have much info about signal/ibis file So Please ignore if it's not valid question. Thanks Abhishek Goswami Phone No -07829580867/9962270999 Skype : abhishekgoswami1 -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -------------------------------------------------------------------- |For help or to subscribe/unsubscribe, e-mail mikelabonte@eda-stds.org |or ibis-request@eda-stds.org | |IBIS reflector archives exist under: | | http://www.eda-stds.org/ibis/email_archive/ Recent | http://www.eda-stds.org/ibis/users_archive/ Recent | http://www.eda-stds.org/ibis/email/ E-mail since 1993Received on Tue Dec 16 05:26:12 2014
This archive was generated by hypermail 2.1.8 : Tue Dec 16 2014 - 05:26:49 PST