[IBIS-Users] How i use 100 ohm receiver resistence in my models

From: Akhilesh CHANDRA <akhilesh.chandra@st.com>
Date: Tue May 18 2004 - 10:02:33 PDT

Hello Friends,

  I have LVDS RECEIVER cell in which a internal terminated 100ohm
resistence is present. How I will incorporate this resistence in my models.
    When I validate my DRIVER and RECEIVER independently then everythis
is fine but when I use a TX line between the driver and reciver the
swing is reduce in my SPICE due to this 100ohm resistence and my SPICE
and IBIS result become differ.

Regards
Akhilesh

|------------------------------------------------------------------
|For help or to subscribe/unsubscribe, email majordomo@eda.org
|with just the appropriate command message(s) in the body:
|
| help
| subscribe ibis <optional e-mail address, if different>
| subscribe ibis-users <optional e-mail address, if different>
| unsubscribe ibis <optional e-mail address, if different>
| unsubscribe ibis-users <optional e-mail address, if different>
|
|or email a written request to ibis-request@eda.org.
|
|IBIS reflector archives exist under:
|
| http://www.eda.org/pub/ibis/email_archive/ Recent
| http://www.eda.org/pub/ibis/users_archive/ Recent
| http://www.eda.org/pub/ibis/email/ E-mail since 1993
Received on Tue May 18 10:01:59 2004

This archive was generated by hypermail 2.1.8 : Tue May 18 2004 - 10:03:26 PDT